Table of Contents
Advertisement
Installation menu
8.5.3 Blend mask setup procedure
Blend mask introduction
The blend mask function blends out an area on the outer edges in the picture. This function is applicable when
e.g. icons in the toolbar in an image from a pc is to be projected.
The blend mask area will be defined in the blend mask setup process.
Blend mask adjustment procedure
1.
Enter the menu Installation/Blend/Blend mask
Image 8–42
2.
By the arrow keys, place the display cursor on respectively the "Enable" zone and the "Show Lines" zone
and activate them by pressing enter.
3.
Use the arrow keys to move the cursor to the position that must be masked. and press enter.
4.
Adjust the mask area (width) by pressing the arrow keys on the remote control. By pressing the key arrow
constantly, the blend value will increase rapidly. The numeric value of the width is shown on both the LCD
screen and the OSD. (The number entered represent the blend width expressed in number of pixels).
5.
Use the enter key to move the cursor to the next position that has to be masked.
6.
Adjust the value by using the arrow keys. (See note below).
7.
Repeat step 4 and 5 to adjust the rest of the blending zones.
8.
Exit the menu by using the exit button on the remote control.
140
R5911705 /02
Bragi
Advertisement
Table of Contents
