Power Off The Projector - Barco G50 Installation Manual

Powering On/Off the projector

4.2 Power off the projector

How to power off the projector
1. Press the Standby button (reference 2) on the remote control or the Power On/Off button (reference 3)
on the control panel.
2
Image 4–4
A confirmation request will be prompted on the screen.
2. Press the same button again to confirm.
Note: If not confirmed after five seconds, the confirmation request will disappear and the projector
will remain on.
CAUTION: Don't power on the projector again immediately after entering standby mode.
CAUTION: Don't switch off or disconnect the projector from the power net until the cooling down
cycle is completed.
48 R5916677 /00 G50
3
ZOOM