Table of Contents
Advertisement
Message
The ice cube maker
and alarm symbols
are flashing on the dis-
play. The indicator light
on the ice cube maker
is also flashing.
lights up in the dis-
play.
The power failure sym-
bol , appears in the
display and the alarm
sounds.
The temperature display
will show the warmest
temperature recorded in
the freezer during a
power failure or an in-
terruption to the power
supply.
"F0 to F9" appears in
the display.
"FE*" appears on the
display.
The symbol has lit up
on the display and the
appliance is not cooling
although the controls
and the interior lighting
are working.
Frequently Asked Questions
Possible cause and solution
There is a fault with the ice cube maker.
Contact Miele Service.
The Replace carbon filter reminder setting has
been activated. This is the reminder to change the
filter (Active AirClean).
Replace the carbon filter in the holder (see
"Cleaning and maintenance - Replacing the filter").
Reset the counter (see "Selecting further settings –
Carbon filter replacement indicator ").
There is a power failure: The temperature in the
appliance over the last few days or hours has risen
too high because of a power failure or interruption to
the power supply.
The appliance will go back to the last temperature
setting when the power is restored.
Press the OK button.
The warmest temperature displayed will disappear.
The display will then revert to showing the current
temperature in the freezer section.
Depending on the temperature displayed, you
should check whether food in the freezer has
started to thaw or has defrosted. If it has, cook it
before freezing it again.
There is a fault.
Contact Miele Technical Service.
There is a fault.
Contact Miele Service.
Demo mode is on. This allows the appliance to be
presented in the showroom without the cooling
system being switched on. Do not activate this
setting for domestic use.
Turn off demo mode (see "Information for dealers -
Demo mode").
75
Advertisement
Table of Contents
