Table of Contents
Advertisement
You can choose:
Factory Reset
The monitor menu offers a Factory Reset option, which will return all the settings of the monitor to the
factory defaults
To reset the monitor press the MENU button and then use the UP / Down button to navigate to FACTORY
RESET option. Press ENTER again to reset the monitor. After a few seconds the monitor will be reset.
5.2 Monitor firmware update procedure
From time to time Datavideo may release new firmware to either add new features or to fix reported bugs
in the current HS-2200 Monitor firmware. Customers can update the firmware themselves if they wish or
they can contact their local dealer or reseller for assistance should they prefer this method.
This page describes the firmware update process and it should take approximately 15 minutes total time
to complete.
Successful firmware upgrade on HS-2200 Monitor requires:
The latest firmware update for the HS-2200 Monitor.
This firmware file can be obtained from your local Datavideo office or dealer.
USB 2.0 pen drive 128MB or larger with a USB A connector.
How to update the firmware
1. Unzip / extract the supplied zipped archive or rar folder.
2. Wipe the contents of the USB 2.0 pen drive so it is empty.
3. Transfer / copy the unzipped / extracted file to the USB 2.0 pen drive; make sure the file name is
renamed to MSTFLASH.bin.
4. Plug the USB 2.0 pen drive into the USB 2.0 port labelled MONITOR F/W UPGRADE on the front of the
monitor button panel.
5. Reboot HS-2200 and the update will be automatically in progress.
6. The HS-2200 Monitor will reboot itself at the end of the process.
Once started the update process should not be interrupted in any way as this could result in a non-
responsive unit.
OSD TIMEOUT
FRAME RATIO
4:3 MARK LINE
CENTRAL MARK
CINEMA ZONE MARK
AUDIO CHANNEL L*
AUDIO CHANNEL R*
26
5-120 SEC
90 / 80 / 0FF
ON / OFF
ON / OFF
ON / OFF
1/2/3/4
1/2/3/4
Advertisement
Table of Contents
