Reset All; Software Version; Escape - Datavideo AD-100 Instruction Manual

N.B. The unit will automatically exit the MENU settings mode if it is left idle for 12 seconds or more.

7. RESET ALL

Please remove all output connections before using this feature.
This option restores the factory defaults which may be louder than expected. Please review and adjust the
default menu settings before re-connecting any output connections on the AD-100 rear panel.
NB: The AD-100 is an Audio Delay device and it can also be used as a Tone Generator. Please DO NOT
connect the AD-100 directly to a headset or set of speakers it should not be used like an Audio AMP.
- Press the MENU button to enter the system configuration settings.
- Turn the ADJUST Knob to select the RESET ALL setting.
- The cursor will flash at the beginning of this menu option.
- Press MENU button again to move the flashing cursor to the setting position.
- Turn the ADJUST knob to change the RESET ALL setting from NO to YES.
- Press the ADJUST knob in for 2 seconds, the system will return to the factory defaults.
- The setting will return to NO.
- Press the MENU or MODE button to start to review the units default settings.

8. SOFTWARE VERSION

- Press the MENU button to enter the system configuration settings.
- Turn the ADJUST knob to select SOFTWARE VERSION.
- The firmware version of the AD-100 is displayed for 12 seconds.

9. ESCAPE

- After reviewing or changing the system configuration settings.
- Turn the ADJUST knob to select ESCAPE.
- Press the ADJUST knob in to exit the system configuration settings mode.
- Alternatively press the MODE button to exit the system configuration settings instantly.
Factory Default Settings
AUDIO_DELAY
DELAY_TIME
ATTENUATION
TONE_OUT
TONE_MODE
TONE_LEVEL
9
OFF
10ms
-0dB
OFF
1KHz
+4dBu