Table of Contents
Advertisement
LOGO 1
The LOGO 1 and LOGO 2 buttons are used to display pre-selected logos on
the HS-2200 Preview and Program outputs. When the button is active the
selected logo is shown. These logos are selected from the switcher's
memory and positioned using a menu option.
LOGO 2 or CLOCK
The user cannot display LOGO 2 and CLOCK at the same time. Instead, use
LOGO 1 and CLOCK together or use LOGO 1 and LOGO 2 together.
FTB
Fade To Black, this button fades the current video program source to black.
When pressed again it acts in reverse from complete black to the currently
selected program video source.
SPEED
There are three speed buttons which can be defined by the user. By pressing
a speed button the user is choosing the rate of transition or time taken
when using the AUTO TAKE button.
Note: Please enter the HS-2200 MENU and select CONSOLE SETTINGS to set
up SPEED BUTTON.
WIPE
The WIPE button is selected when a wipe effect transition between the
selected Program and Preset sources is required. This WIPE effect is
produced by then moving the T-Bar manually or by pressing the AUTO
TRANS button.
CUT
This performs a simple immediate switch from the current main source to
the selected sub source. The selected transition wipe or MIX is not used.
AUTO TAKE
This performs an automated switch from the current program source to the
selected Preview source. The selected transition wipe or MIX will also be
used. The timing of the transition is set by the chosen Speed button.
MIX
Pressing this button selects a basic A/B Dissolve for the next transition.
16
Advertisement
Table of Contents
