Avaya S8300 Manual page 71

Task
14. Verify LSP status (if
any)
15. If the LSPs (if any)
translations have not
synchronized with the
ICC, invoke translation
synchronization.
LSP mode: On the S8300B's primary controller
16. Verify S8300B LSP
status (if any)
ICC mode: On the S8300B
At the ICC's SAT prompt, enter display
lsp.
The LSP name and IP address should be
listed. The Service State? field should be
in-service/idle.
The Translations Updated should match
the translations date and time on the ICC.
To view the ICC's translations date and
time, enter list configuration
software.
On the ICC, enter the Linux command
filesync -a trans.
Ensure that the translation synchronization
completed successfully.
Wait several minutes, then check the
timestamp of the LSP's translation files
using the SAT command display lsp on
the ICC.
At the primary controller's SAT prompt,
enter display lsp.
The S8300B LSP name and IP address
should be listed. The Service State? field
should be in-service/idle.
The Translations Updated should match
the translations date and time on the
primary controller. To view the primary
controller's translations date and time,
enter list configuration software.
Steps/Comments
Issue 2 June 2005 71