Avaya S8300 Manual page 24

Converting an S8300 from LSP to ICC and upgrading Communication Manager from 1.x to 2.x
20. Reboot the ICC.
21. Reassign endpoints
from the former
primary controller to
the standalone ICC.
For information on
updating translations, see
the Administrator Guide for
Avaya Communication
Manager, 03-300509.
22. Remove endpoints
from the current
primary controller that
will be controlled by
the new ICC.
23. Upgrade the gateway
Firmware.
Start on page 267.
24. If using IA770, install
service pack (or RFU)
files, if any.
Page 275.
25. Reboot LSPs (if any)
26. Verify LSP translations
date and time (if any).
24 Converting an Avaya S8300 Media Server Between ICC and LSP Modes
Task
On LSPs of the new ICC (if any)
Steps/Comments
Open a SAT session and enter reset system
4.
After the reboot, any LSPs should be registered
with the ICC, and in a few minutes translations
should be synchronized.
Update translations — add stations and
trunks to the new ICC— using the Avaya
Installation Wizard and the Electronic
Pre-Installation Worksheet (EPW) or SAT
commands.
Place test calls to verify.
Reassign messaging system users of the
current primary controller to the messaging
system used by the new ICC. Enter test
messages to verify.
Remove endpoints from the current
primary controller.
Using the Avaya Installation Wizard on the
new ICC Web Interface to upgrade the
gateway firmware is recommended.
Alternatively, you can use the gateway's
MGP CLI commands starting on page 145.
At the LSP's SAT prompt, enter reset system
4.
To view the LSP's translations date and time,
enter list configuration software.