Avaya S8300 Manual page 32

Converting an S8300 from ICC to LSP and upgrading Communication Manager from 2.0.x to 2.x
11. Upgrade the S8300B.
Starting on page 239,
ending on page 250.
12. Set time, date, and time
zone.
Page 259.
13. Install post-upgrade
service pack file, if any.
Page 260.
14. Install the LSP license file.
Starting on page 263.
15. Install the authentication
file.
Starting on page 264.
16. Configure server.
Starting on page 464,
ending on page 478.
17. Reboot the LSP.
18. Upgrade the gateway
Firmware.
Start on page 267.
32 Converting an Avaya S8300 Media Server Between ICC and LSP Modes
Task Steps/Comments
Set Telnet parameters.
Remaster hard drive and install upgrade software.
Select No on the Install AUDIX screen.
Verify software version.
Copy files to the S8300B (license file,
authentication file, service pack file).
The time of the LSP must be set to the same time zone as
its primary controller, even if the LSP is physically located
in a different time zone.
Skip the Verify Media Server Configuration section
starting on page 247.
Fill in each Configure Server screen with data for
the LSP. Some of the configuration data will be the
same as that for the ICC.
On the Configure Local Survivable Processor
screen, select one of the three LSP choices
depending on the primary controller type.
Open a SAT session and enter reset system 4.
After the reboot, the LSP should be registered with the
primary controller and in a few minutes translations
should be synchronized.
Using the Avaya Installation Wizard on the LSP
Web Interface to upgrade the gateway firmware is
recommended.
Alternatively, you can use the gateway's MGP CLI
commands starting on page 298.