Avaya S8300 Manual page 45

Converting media server between icc and lsp modes

Hide thumbs Also See for S8300:

Chapter 5: Converting an S8300 from ICC to LSP

This chapter provides a high-level list of tasks for converting an S8300B primary controller to

LSP mode without performing an upgrade. To complete these tasks, you will need the following

additional documents:

Installation and Upgrades for Avaya G700 Media Gateway and Avaya S8300 Media

Server, 555-234-100. To obtain this document, go to

navigate to Installations, Migrations, Upgrades & Configurations; then select the

appropriate document.

Administrator Guide for Avaya Communication Manager, 03-300509.

Converting between an ICC and

documents for non-US systems should be available from the regional web sites.

In this scenario, an S8300B, configured as an ICC, is converted to an S8300B in LSP mode. In

both modes, the media server is running Communication Manager release 2.1 or later and no

software/firmware upgrade is performed.

The tasks include:

1. Administering the primary controller for the new LSP.

2. Moving the endpoints supported by the ICC to the new primary controller.

3. Updating the DHCP server alternate controller list.

4. Updating the gateway MGC list.

5. Configuring the S8300B as an LSP.

Follow the detailed procedures in Installation and Upgrades for Avaya G700 Media Gateway

and Avaya S8300 Media Server, 555-234-100, Issue 8, April 2005, for most of the tasks in this

conversion scenario.

(Communication Manager 2.1 or later)

http://support.avaya.com

LSP, which is for U.S.-based systems only. Similar

and

Issue 2 June 2005