Avaya S8300 Manual page 57

Task
19. Reassign endpoints
from the current
primary controller to
the standalone ICC.
For information on
updating translations, see
the Administrator Guide for
Avaya Communication
Manager, 03-300509.
20. Reboot the ICC.
21. Remove endpoints that
will be controlled by
the new ICC from the
current primary
controller.
22. Verify that the media
gateway has
registered with the
ICC.
23. Reboot LSPs (if any)
24. Verify LSP translations
date and time (if any).
Update translations — add stations and
trunks
- Using the Avaya Installation Wizard and
the Electronic Pre-Installation Worksheet
(EPW) is recommended.
- Alternatively, use SAT commands.
Place test calls to verify.
Reassign messaging system users of the
current primary controller to the messaging
system used by the new ICC. Enter test
messages to verify.
Open a SAT session and enter reset system
4.
After the reboot, any LSPs should be registered
with the ICC, and in a few minutes translations
should be synchronized.
On the LSP's primary controller
Remove users/endpoints from the current
primary controller.
On the new ICC
Open a SAT session and enter list
media-gateway. Verify that the
Registered field (Reg?) is set to y.
Place a test call.
On LSPs of the new ICC (if any)
At the LSP's SAT prompt, enter reset system
4.
To view the LSP's translations date and time,
enter list configuration software.
Steps/Comments
Issue 2 June 2005 57