Avaya S8300 Manual page 13

Task
7. If IA770 is installed, get
IA770 data and stop
IA770.
Page 225.
8. Install pre-upgrade
software service pack,
if necessary
Page 233.
9. Perform data backup.
Pages 229 and 235.
10. Record configuration
information.
Page 226.
11. Replace the S8300A
with the S8300B, if
necessary.
Page 238.
12. Upgrade the S8300B.
Starting on page 239,
ending on page 250.
Pre-upgrade service pack requirements
Steps/Comments
On the ICC/LSP
See Pre-upgrade service pack requirements
page 10
Backup according to the release from which you
are upgrading. See Pre-upgrade service pack
requirements on page 10
You will not restore these data sets. It is important
to have them in case it is necessary to revert to
the original configuration.
If you have not already done so, in the Record
Configuration Information task, record all of the
configuration information, regardless of the
release from which you are upgrading.
You will re-enter some of this information after the
upgrade.
Shut down the S8300A.
Remove the S8300A from the gateway. (If
the gateway is a G700, the LED panel
must be removed together with the
S8300A.)
Re-insert the S8300B (together with the
LED panel for a G700) into the gateway.
Set Telnet parameters
Remaster hard drive and install upgrade
software
Select No on Install AUDIX screen.
Verify software version
Copy files to the S8300B (license file,
authentication file, service pack file)
on
Issue 2 June 2005 13