Avaya S8300 Manual page 61

At the customer site
Perform the tasks in this section at the customer site.
Go to the standard documentation
Use Installation and Upgrades for Avaya G700 Media Gateway and Avaya S8300 Media
Server, 555-234-100, Issue 8, April 2005.
To convert the G350 LSP to a G700 LSP, you complete selected tasks from Chapters 2 and 3.
You need to complete only some of the tasks in these chapters. The specific tasks are
identified by page number in the left-hand column. The subtasks to perform or skip are listed in
the right-hand column.
It is important to note where the task is performed. Most of the tasks are done on a server or
gateway — on the LSP S8300B, on the primary controller for the LSP, on a DHCP server, or on
the G700 media gateway processor (MGP). The headings in the table indicate on which of
these devices the task is performed.
1. Backup all system files —
translations, OS, and
security backup sets.
Start on page 229.
2. Record configuration
information
Page 232.
3. Install the G700 media
gateway hardware.
Page 86.
4. Shut down the S8300B in
the G350.
5. Remove the S8300B
Media Server.
Task Steps/Comments
On the G350 LSP
These backup sets will be restored on the G700 LSP.
If you have not already done so, in the Record
Configuration Information task, record all of the
configuration information, regardless of the fact that you
are not upgrading Communication Manager.
You will re-enter some of this information after the
conversion.
Unpack, check, and mount the G700 in a rack.
Note:
The final disposition of the G350 Media
Note:
Gateway is beyond the scope of this
procedure.
Place in a safe, static-free place.
Issue 2 June 2005 61