Avaya S8300 Manual page 42

Converting an S8300 from LSP to ICC and upgrading Communication Manager from 2.0.x to 2.x
21. Remove endpoints
from the current
primary controller that
will be controlled by
the new ICC.
22. Reboot LSPs (if any)
23. Verify LSP translations
date and time (if any).
24. Verify LSP status (if
any)
25. If the LSPs (if any)
translations have not
synchronized with the
ICC, invoke translation
synchronization.
26. Upgrade the gateway
Firmware.
Start on page 267.
42 Converting an Avaya S8300 Media Server Between ICC and LSP Modes
Task
On LSPs of the new ICC (if any)
Steps/Comments
Remove endpoints from the current
primary controller.
At the LSP's SAT prompt, enter reset system
4.
To view the LSP's translations date and time,
enter list configuration software.
On the ICC
At the ICC's SAT prompt, enter display
lsp. The LSP name and IP address
should be listed. The Service State? field
should be in-service/idle.
The Translations Updated should match
the translations date and time on the ICC.
To view the ICC's translations date and
time, enter list configuration
software.
On the ICC, enter the Linux command
filesync -a trans.
Ensure that the translation synchronization
completed successfully. Wait several
minutes, then check the timestamp of the
LSP's translation files using the SAT
command display lsp on the ICC.
Using the Avaya Installation Wizard on the
new ICC to upgrade the gateway firmware
is recommended.
Alternatively, you can use the gateway's
MGP CLI commands starting on page 144.