Avaya S8300 Manual page 50

Converting an S8300 from ICC to LSP (Communication Manager 2.1 or later)
16. Verify LSP status.
17. If the LSP's translations
have not synchronized
with the primary
controller, invoke
translation
synchronization.
18. Implement any additional
design changes to voice
and/or voice messaging
networks.
19. Re-register the S8300 as
an LSP with the Avaya
remote servicing center.
50 Converting an Avaya S8300 Media Server Between ICC and LSP Modes
Task
On the LSP's primary controller
Steps/Comments
At the SAT prompt, enter display lsp. The LSP
name and IP address should be listed. The
Service State? field should be in-service/
idle.
The Translations Updated should match the
translations date and time on the primary
controller. To view the primary controller's
translations date and time, enter list
configuration software.
On the primary controller, enter the Linux
command filesync -a ipaddress
where ipaddress is the IP address of the LSP.
Ensure that the translation synchronization
completed successfully. Wait several minutes, then
check the timestamp of the LSP translation files
using the SAT command display lsp on the
primary controller.
Post-conversion tasks