Call Screening; Troubleshooting - Oricom CARE620 Series User Manual

TROUBLESHOOTING

Note: If your answering machine is switched off, the phone will answer
the call after 10 rings. You can press <*> and then enter the 4-digit
remote access PIN (Default Remote Access PIN is 0000) to activate the
remote access feature.

4. Call Screening

When the answering machine is set to ON and there is an incoming
message, the base will start call screening automatically after the preset
numbers of rings of answer delay.
At any time if you want to pick up the call, you can press < TALK ON> on
the handset and the message recording will be stopped automatically.
If the answering machine is in the process of recording, the message
already stored will be saved.
TROUBLESHOOTING
If you have difficulty with your phone, please try the suggestions listed
below.
Problem
No dialing tone when
pressing <TALK ON>
key
When connected to
a PBX, no and/or
wrong connection after
dialing.
Cause
a. The connection cord
of the base station
may not be plugged in.
b. The adaptor cord
may not be plugged in
correctly in the base
station.
c. The line may be
busy.
Dialing prefix is
needed.
46
Solutions
a. Check the
connections. Unplug
and plug back in the
mains. Check that the
telephone line cord
has been plugged into
the base station and
the phone socket.
b. Check the base
station and mains
plugs are connected
correctly. (remove and
plug-in).
c. Wait until the line is
unoccupied.
Insert the dialing
prefix.