Change The System Pin Code; Nz Setting; Handset Settings; Set The Ringer Volume - Oricom CARE620 Series User Manual

PHONE SETTINGS

Change the System PIN Code

The default system PIN code is 0000.
1. Press <MENU/OK> then <UP> or <DOWN> to select BS SETTINGS.
2. Press <MENU/OK> then <UP> or <DOWN> to select CHANGE PIN.
3. Press <MENU/OK>, you are then requested to enter the 4-digit
system PIN.
4. Enter the old system PIN.
5. Press <MENU/OK> and enter the new system PIN.
6. Press <MENU/OK> and enter the new system PIN again.

NZ Setting

1. Press <MENU/OK> then <UP> or <DOWN> to select BS SETTINGS.
2. Press <MENU/OK> then <UP> or <DOWN> to select NZ.
3. Press <MENU/OK> then <UP> or <DOWN> to select ON or OFF.
4. Press <MENU/OK> to confirm.
Remark: when set to ON, the New Zealand area code management is
enabled.

Handset Settings

Set the Ringer Melody for Internal Calls or External Calls
1. Press <MENU/OK> then <UP> or <DOWN> to select HS SETTINGS.
2. Press <MENU/OK> then <UP> or <DOWN> to select RING SETUP.
3. Press <MENU/OK> then <UP> or <DOWN> to select INT RING or
EXT RING
4. Press <MENU/OK> then <UP> or <DOWN> to select the desired
ringer melody (a total of 10 melodies for your selection) for internal
calls.
5. Press <MENU/OK> to confirm.

Set the Ringer Volume

1. Press <MENU/OK> then <UP> or <DOWN> to select HS SETTINGS.
2. Press <MENU/OK> then <UP> or <DOWN> to select RING SETUP.
3. Press <MENU/OK> then <UP> or <DOWN> to select RING
VOLUME.
32