Package Contents; Necessary Equipment; System Setup - Xilinx FMC XM101 LVDS QSE User Manual

Chapter 1: XM101

Package Contents

The following items are included in the XM101 shipment:
•
•
•
•
•

Necessary Equipment

•
•

System Setup

Complete the following steps to install the XM101 to a Xilinx board. For additional
information on Xilinx boards, refer to the particular board's user guide. See
Documentation, page
1.
2.
3.
4.
5.
6.
7.
The system is now ready for use.
8
XM101 card
Four (4) mounting screws
Two (2) standoffs
One (1) Samtec EQDP-028-12.00-TEU-TED-1 28-pair 12 inch loopback cable
Welcome letter
Small Phillips screwdriver to secure the XM101 to the board
PC with Internet access to download documentation, board files, and schematics
5.
Turn off the ML605 board's DC power switch and disconnect its input power source.
Remove the XM101 from the electrostatic device (ESD) bag.
Using a small Phillips screwdriver, remove the two screws from the bottom side of the
two standoffs on the XM101.
Install the XM101 to the ML605 FMC HPC connector J64. The XM101 hangs off the
edge of the ML605 board as shown in
Turn the ML605 and attached XM101 board over such that the ML605 FPGA is facing
the table. Install two screws from the bottom side of ML605 board's FMC HPC
mounting holes into the two standoffs attached to the XM101. Hand tighten the two
mounting screws to the bottom of the board.
Turn the ML605 and attached XM101 boards over such that the Xilinx FPGA is visible.
Connect the input power source to the ML605 board. Turn the ML605 board power
input switch to ON.
www.xilinx.com
Figure 1-1, page 9.
FMC XM101 User Guide
UG538 (v1.1) September 24, 2010
Additional