Sealing The Connection Area - Kaco blueplanet 3.0TL3 Series Manual

Connect Powador-protect
↻ The cable to the external grid protection device is available on the device.
↻ Cover of the device has been opened.
1 Undo the cable fittings [ W_20]
2 Pass the connection cable through the cable fittings.
3 Connect wire A (+) to the terminal marked "INV OFF+" on the first device via the
"DO1" terminal of the protective device.
4 Connect wire B (-) to the terminal marked "INV OFF-" on the first device via the
"GND" terminal of the protective device.
5 Connect the other devices to one another as follows:
- wire A (+) to wire A (+) and wire B (-) to wire B (-).
6 Tighten the cable fitting [ W_20 /
7 After commissioning: Configure the external Overvoltage protection
Powador-protect in the menu entry Properties / Functions Proper-
ties / functions.
7.8

Sealing the connection area

↻ Grid connection is prepared.
1 Feed the cables into the cover.
2 Place the cover at the marked position and click into place.
3 Set the DC isolator switch to "1".
» Put the device into operation.
KACO blueplanet 3.0TL3 KACO blueplanet 4.0TL3 KACO blueplanet 5.0TL3 KACO blueplanet 6.5TL3 KACO blue-
planet 7.5 TL3 KACO blueplanet 8.6TL3 KACO blueplanet 9.0TL3 KACO blueplanet 10.0TL3
6 5 4
1.5 Nm]
Powador-
x
INV
RS485
protect
OFF
A
D01
GND
A B A B
+ - B 4
3
GND GND
2
2 1
1
A B
y
x
y
RS485 INV
OFF
INV Signal
A B A B + -
GND GND
Fig. 37: Connecting the device to
Powador-protect
Fig. 38: Close the connection cover
Page 31