Sealing The Connection Area - Kaco blueplanet 29.0 TL3 M1 OD II4S Manual

↻ Only suitable KACO inverters can be used.
↻ Housing doors open.
1 Undo the cable fittings [ W_20]
2 Pass the connecting cable through the cable fittings.
3 Connect wire A (+) to the terminal marked "EVU+" on the first device via the
"DO1" terminal of the Powador-protect.
4 Connect wire B (-) to the terminal marked "EVU-" on the first device via the
"GND" terminal of the Powador-protect.
5 Connect the other devices to one another as follows:
- wire A (+) to wire A (+) and wire B (-) to wire B (-).
6 Tighten the cable fitting [ W_20 /
7 After commissioning: Activate the support for Powador protect in the para-
meter menu under the "Powador-protect" menu option.
7.9.7 Laying the signal lines
7.10

Sealing the connection area

1 The requirements of protection class IP65 are met by closing the unused cable fittings with blind caps.
2 Close the housing door and lock it with a control cabinet key.
» The device has been mounted and installed.
Page 32
1.5 Nm]
Powador-
x
RS485
INV
protect
OFF
A
D01
GND
BA BA
- B
+ 4
B A
3
GND GND
2
2 1
1
y
x
y
INV RS485
OFF
INV Signal
BA BA
+
-
GND GND
Fig. 38: Connect the device to
Powador-protect
Kaco blueplanet 29.0TL3