Installing And Securing The Device - Kaco blueplanet 3.0TL3 Series Manual

6.4

Installing and securing the device

CAUTION
Risk of injury from improper lifting and transport.
If the device is lifted improperly, it can tilt and result in a fall.
› Always lift the device vertically using the openings provided.
› Use a climbing aid for the chosen installation height.
› Wear protective gloves and safety shoes when lifting and lowering the device.
NOTE
Power reduction due to heat accumulation!
If the recommended minimum clearances are not observed, the device may go into power regulation
mode due to insufficient ventilation and the resulting heat build-up.
› Observe minimum clearances and provide for sufficient heat dissipation.
› All objects on the device housing must be removed during operation.
› Ensure that no foreign bodies prevent heat dissipation following device installation.
2
1
Fig. 14: Lifting the housing
Key
1 Opening
2 Centre of gravity
Lifting and installing the device
↻ The mount has been installed.
1 Lift the device using the lateral openings . Observe the device's centre of gravity!
2 Fit the device onto the upper mount by means of the mounting bracket. Fit the device onto the lower mounting
bracket in full so that the device sits flush with its rear side on the mount. [See figure 15] [} Page 19]
3 Insert the screw provided into the lug of the mount and secure the device to prevent it from being lifted off [ X Z2
(Pozidrive) / 2 Nm] [See figure 12] [} Page 18].
NOTE: Alternatively: At this point, the screw described above can be replaced by a special screw as anti-theft pro-
tection.
» Device is installed. Proceed with the electrical installation.
KACO blueplanet 3.0TL3 KACO blueplanet 4.0TL3 KACO blueplanet 5.0TL3 KACO blueplanet 6.5TL3 KACO blue-
planet 7.5 TL3 KACO blueplanet 8.6TL3 KACO blueplanet 9.0TL3 KACO blueplanet 10.0TL3
Fig. 15: Mounting the device
3 Insertion lugs
4 Mounting bracket
3
4
Page 19