Ethernet Connection; Sealing The Connection Area - Kaco 50.0TL3-S B1 WM OD IIGL Quick Manual

Fig. 10: Communication circuit board: Connection and assignment of the interfaces
1 Communication circuit board
2 ERR – Connection for fault signal relay
3 USB – Connection for update

4.6.2 Ethernet connection

NOTE
The connection plug of an RJ45 cable is larger than the opening of an M25 cable fitting when it is installed.
For this reason, remove the sealing insert before installation and thread the Ethernet cable outside of the
cable fitting through the sealing insert.
NOTE
Use a suitable category 5 network cable. The maximum length of a network segment is 100 m. Ensure that
the cable is correctly assigned. The Ethernet connection of the device supports auto-sensing. You can use
both crossed and 1:1 protectively-wired Ethernet connection cables.
↻ Connecting cable inside the device.
1 Plug in an Ethernet cable at one of the two Ethernet ports on the communication circuit board.
2 Lay the Ethernet cable correctly in the lower AC supply area and loosely fasten it using the cable ties provided.
3 Tighten the cable fittings [[
4.7

Sealing the connection area

1 The requirements of protection class IP65 are met by closing the unused cable fittings with blind caps.
2 Close the housing door and lock it with a control cabinet key.
» The device has been mounted and installed.
5 Configuration and operation
5.1 Signal elements
The 3 LEDs on the device control panel show the different operating states. The LEDs can display the following states:
LED illuminated
Operating status
Start
Start grid operation
Page 10
ERR USB
1
3
2
W_29 / 4 Nm].
LED flashing
LED Icon Display
Charging /discharging cur-
rent
Ethernet
4
4 Ethernet – Connection for communication
5 INV OFF – connection for KACO "powador-pro-
tect"
LED not illuminated
Description
The green "Operating" LED is on when
the AC voltage is present, independent of
the DC voltage.
The green "Operating" LED is lit.
The green "grid operation" LED is
lit after the country-specific waiting
period*.
Ready for grid operation.
The interface switch engages audibly.
KACO blueplanet gridsave 50.0TL3-S
INV
OFF
DIP Optional
H L H L
5