Table of Contents
Advertisement
Chapter 4. Specifications
4.1 Specifications
Table 4.1 lists specifications of the M306K9T2-CPE.
Table 4.1 Specifications of the M306K9T2-CPE
Applicable MCUs
Usable mode
Evaluation MCU
Emulation memory
Clock supply
Maximum operating frequency
Minimum operating frequency
Applicable target power supply
Basic debugging functions
Real-time trace function
Real-time RAM monitor function
Hardware break function
Execution time measurement function
Operating temperature
Storage temperature
Connection to target system
Power supply for emulator
Host machine interface
M16C/6K Group M306K9
Single-chip mode
M30622SAFP, M306K9F0LFP
For internal RAM area: 5 KB
For internal ROM area: 128 KB
Internal oscillator circuit (OSC-3)
Main clock (X
)
IN
Switchable to external oscillator input
Clock mounted on emulator (32.768 kHz)
Sub clock (X
)
CIN
Switchable to external oscillator input
16 MHz at 3.3 V (divide-by-1, no-wait)
32.768 kHz
With the target
3.0 to 3.6 V
(supplied from pin Vcc of the target system)
(JP1 = EXT)
Fixed to 3.3 V
Without the target
(JP1 = INT)
(supplied from the emulator)
• Download, software break (max. 64 points)
• Program execution/stop (allows free-run execution supporting
software breaks)
• Memory reference/setting (reference/setting C-variables, run-
time execution)
• Register reference/setting
• Disassemble display
• C-level debugging, etc.
• 32K-cycle bus information recordable
(Address: 20 bits, Data: 16 bits, MCU status: 12 bits)
• 2 trace modes supported (Before Break mode/After Go mode)
1024 bytes
1 point (Address break, R/W break, 256 pass counts)
Time between program start to stop
5 to 35°C (no dew)
-10 to 60°C (no dew)
For M306K9:
144-pin 0.4-mm-pitch QFP (144PFB-A) converter board
M3T-FLX-144NSE (option)
DC 5.0 V ±5% (2 A) externally supplied (prepare the power supply
separately)
USB (USB 1.1 full-speed, mini-B standard connector used)
( 38 / 56 )
Advertisement
Table of Contents
Troubleshooting
