Table of Contents
Advertisement
VIFB13 - 03/05
Valve terminal
Hat rail clamping unit
locked
Fig. 2/5: Fitting valve terminal type 03 onto a hat rail
9809b
2. Fitting
•
Make sure that the fastening surface can
carry this weight.
•
Fit a hat rail (support rail EN 50022 - 35x15;
width 35 mm, height 15 mm).
•
Fasten the hat rail to the mounting surface at
least every 100 mm.
•
Hang the terminal onto the hat rail. Secure
the terminal on both sides against tilting or
slipping with the hat rail clamping unit (see
diagram below).
•
If the terminal is fitted in a sloping position or
at a point subjected to vibration, use the two
screws (7) to protect the hat rail clamping unit
against unintentional loosening/opening.
type 03
Retaining screw (7)
2-11
Advertisement
Table of Contents
