Leica R9 Instructions Manual page 205

possible as alternative to automatic compensation. Operating
displays depend on the setting and current operation in the
flash display and camera viewfinder (where
also appear if above or below the flash range). With a manually
set ( m ) or automatically controlled ( A ) shutter speed of
1/250 s or slower: Without pre-flash: Normal, TTL controlled
fill-in flash exposure; with pre-flash: guide number controlled
fill-in flash exposure according to the calculated subject
distance and based on the TTL pre-flash metered result.
Strobe flash mode (multiple flashes fired during an exposure)
Automatic adjustment of exposure time with system-compa-
tible and appropriately equipped flash units.
Flash metering cells Silicon photo diodes in bottom of came-
ra protected from stray light.
Film speed range for TTL flash exposure metering
For SCA controlled metering: ISO 12/12° to ISO 3,200/36°
For test flash metering: ISO 25/15° to ISO 400/27°
Displays in flash mode Readiness status: Flashing of con-
stant illumination of flash symbol in viewfinder and rear panel
LCDs. Success check: Over- and underexposure indicated by
or signal in camera viewfinder for approx. 4s after exposure.
Flash exposure compensation ± 3
SCA 3002 standard flash units or on the SCA 3501/3502M3
adapter with TTL and computer control of the flash unit in
camera modes m , T and A . Fixed –1
program mode and normal lighting conditions, manual com-
1
pensation (± 3 / EV) also possible.
3
On the LEICA SF20, ± 3 EV can be set in
control or in 1 EV steps with computer control.
Automatic adjustment of flash reflector for system-compa-
tible SCA 3000/3002 standard flash units with motor zoom
reflector, SCA 3501/3502M3 adapters and lenses with electri-
cal contacts.
/ warnings
1 1
/ EV in / EV steps on
3 3
2
/ EV preset for automatic
3
1
/ EV steps with TTL
3
Viewfinder system
Prism Built-in penta prism
Eyepiece High-eye-point viewfinder. Diopter compensation of
approx. ± 2 dpt. can be set on the viewfinder. Additional correc-
tive lenses from – 3 to + 3 dpt. are available. Built-in eyepiece
lock.
Focusing screens Interchangeable, 5 models available:
Universal screen (ground glass screen with micro-prism ring
and split-image, standard equipment), uniform ground glass
screen, uniform ground glass screen with grid divisions, micro-
prism screen, clear glass screen with cross hairs
Viewfinder field 23 x 35 mm, equivalent to 93 % of film format
(96 % vertical x 97 % horizontal) and the standard slide format.
Magnification 0.75 x with 50mm lens set to infinity and 0 dpt.
Displays
Viewfinder LCD lines below viewfinder image showing: Warning
symbol if below metering range, indication of exposure com-
pensation or manual film speed setting differing from DX value,
symbols for metering method incl. display for metering
memory-lock, flash symbol, flash ready and flash check, flash
exposure compensation, mode display, aperture display in half
steps, including values dependent on focal length for zoom lenses
with variable aperture, light balance for manual exposure
adjustment, exposure compensation, automatic exposure
series and metering flash mode, shutter speed or over/under-
exposure signals, long-time exposure signal or for impossible
camera settings, frame counter with display of multiple exposu-
res, automatic exposure series and incorrectly loaded film
199