Power On/Off; Setting The Synchronization - Yamaha O2R Owner's Manual

16 Getting Started
POWER
ON/ OFF
02R Getting Started Guide

Power ON/OFF

This section explains how to power the 02R on and off.
Power ON
It is always important to observe the correct order for powering up
equipment in a studio. Always start with the multitrack and mastering
recorders and the signal processors, then the 02R, and finally the
monitoring amplifiers and other downstream gear.
1. Turn ON the power to the 02R by pressing the POWER switch on
the rear panel.
The 02R start-up screen appears for a few seconds, the faders return to their
previous positions, then the page that was used when the 02R was last
powered off appears.
Power OFF
It is always important to observe the correct order for powering off
equipment in a studio. Always start with the monitoring amplifiers and
other downstream gear, then the 02R, and finally the multitrack and
mastering recorders and the signal processors.
1. Turn OFF the power to the 02R by pressing the POWER switch on
the rear panel.
All mix settings, mix scenes, and other data are stored when the 02R is
powered off.

Setting the Synchronization

Before you use the 02R with a modular digital multitrack recorder or DAT
master recorder, be sure to correctly set the synchronization. The 02R must
be slaved to an external wordclock in order to process the input digital
signals without drop-out or distortion. Refer to the section "Word Clock
Select" on page 188 of the User's Guide.
Look in the chapter "Installing Options" on page 217 of the User's Guide.
There is a section for each of the optional digital I/O cards that the 02R
supports. Refer to the appropriate section for the card installed in your 02R.