Yamaha O2R Owner's Manual page 362

252 Specifications
Error Message
Fixed Fragmentation!
Frame Drop Out!(#)
Frame Jump!
ID Mismatch!
Illegal Time Range!
Low Battery!
MAIN SCI0 Framing Err.
MAIN SCI0 OverRun Err.
MAIN SCI0 Party Err.
MAIN SCI0 RxBuf. Full
MAIN SCI0 TxBuf. Full
MAIN SCI1 Framing Err.
MAIN SCI1 OverRun Err.
MAIN SCI1 Party Err.
MAIN SCI1 RxBuf. Full
MAIN SCI1 TxBuf. Full
MAIN->SUB Disconnected!
Make New Mix!
Memory Full!
MIDI Ch Mismatch (#)
No Aux Send!
No Time Code!
Preset is read only!
Redone.
Scene 0 is read only!
Scene Memory Protected!
Select Channel!
Select Parameter!
Set Overwrite!
SOLO Ready!
SOLO Slave!
SUB->MAIN Disconnected!
SUB SCI0 Framing Err.
SUB SCI0 OverRun Err.
02R User's Guide
The automix memory has been corrected. Abnormal data may be
generated in the memory if you turn off the power during recording
or if incomplete bulk data is received.
Time code frame is dropping out.
(The count in the parenthesis shows the number of dropping
frames.)
Time code frame is dropping out.
Model ID for parameter change is not correct.
In/out time setting is incorrect.
The internal battery voltage is getting very low. Back up the setup data
stored in the 02R (see "Bulk Dump/Request" on page 161 of the User's
Guide ), and ask your dealer to replace the battery.
Consult the nearest YAMAHA service center.
Consult the nearest YAMAHA service center.
Consult the nearest YAMAHA service center.
MIDI data being transmitted is too large.
MIDI data being received is too large.
Check the connection at the TO HOST connector.
Check the connection at the TO HOST connector.
Check the connection at the TO HOST connector.
Check the connection at the TO HOST connector.
Check the connection at the TO HOST connector.
Consult the nearest YAMAHA service center.
First make a New Mix.
Automix memory is full.
The device number of the received bulk data is not correct.
There is no AUX send from EFF1 to AUX7 or EFF2 to AUX8.
Time code is not being input.
You cannot store data to the preset memory.
The previous operation was redone.
You cannot store data to Scene "0."
Scene memory is write-protected.
A channel for extract has not been assigned.
The parameter for extract has not been assigned.
Set the overwrite parameter.
The track is ready for solo.
You cannot change the solo status and the Solo key is disabled if the
unit is a cascade slave.
Consult the nearest YAMAHA service center.
Consult the nearest YAMAHA service center.
Consult the nearest YAMAHA service center.
Corrective Action