Yamaha O2R Owner's Manual page 51

42 Secondary Recording Tutorial
AUX 1 AUX 2 AUX 3 AUX 4
AUX 7 AUX 8
AUX 5 AUX 6
EFF1 EFF2
AUX
AUX 1 AUX 2
AUX 3 AUX 4
AUX 5 AUX 6
AUX 7 AUX 8
EFF1 EFF2
SEND LEVEL ON
AUX
02R Getting Started Guide
Aux Sends
The 02R has eight aux sends.
AUX 7 and AUX 8 are used to feed the internal effects processors, with the
signal remaining entirely in the digital domain.
The other auxiliary sends—AUX 1 through AUX 6—can be used to feed
external signal processors and effects units, foldback amplifiers, or
multitrack recording equipment. AUX 5 and AUX 6 can also be used to
construct a monitor mix, and routed directly to either the studio or control
room monitors. When a send is used to feed an external effects processor,
the processed signal can be returned via one of the stereo input channels or
an unused input channel.
There are two different ways to access the auxiliary send channels:
DISPLAY ACCESS—AUX buttons
• The [AUX 1] to [AUX 6] buttons access the AUX 1 to 6 pages, which
display the aux send level controls and pre/post icons.
• The [AUX 7] and [AUX 8] buttons access the AUX 7 and 8 pages, which
are used with the internal effects processors: Effect 1 and Effect 2.
When an AUX button is pressed, the faders and rotary encoders control aux
send levels, not channel levels.
SELECTED CHANNEL—AUX controls
These buttons and controls set the aux send levels for the selected channel.
• The [AUX 1] to [AUX 8] buttons allow you to select the aux buses you
want to send the selected channel signal to.
• The SEND LEVEL rotary encoder is used to set the level—indicated by
the adjacent LED bargraph.
• The [ON] button is used to turn the send on or off.