4.11.2 To Create A Dlc To Call A User - Multitone ACCESS 3000 COMPACT Supervisor Manual

4.11.2 To create a DLC to call a User

1. Enter the user number, e.g. 123 and press Enter
2. You will now be required to select the paging call priority, either press Enter to
confirm the default priority or press the
options. Having made your selection press Enter twice.
3. If the Speech MCU option is available and speech is required, press 1
followed by Enter. Alternatively, if speech is not required press 0 followed by
Enter.
4. If an additional Management Control Unit (MCU) is connected to Access 3000
Compact you may select the speech source. Press the
the MCU options, press Enter twice to select confirm.
5. You may enter an alphanumeric message, e.g. Evacuate All Staff, press
Enter twice to select and confirm. Alternatively, you may select a pre-set
message, use the ↓ key to scroll the list of pre-set messages and press Enter
to select and confirm.
6. At the following prompt you may:
Enter an alphanumeric message, e.g. Evacuate All Staff, then press Enter to
select. Alternatively, you may select a pre-set message, use the ↓ key to
scroll the list of pre-set messages and press Enter to select.
7. At the following prompt you may:
a. Complete the entry and add a new DLC record, press Enter then at the
prompt Changes Saved and press Enter again to create further records or
b. Complete the entry and return to the main menu, press Enter followed by
Ctrl 1 or
c. Add a DLC Output at the above prompt enter the DLC Output record
number, e.g.10 then press Enter.
9261-7849 Issue 1
01 User 123
User
01 _
Enter Message, ↓ - Alpha Code
01 Output _
Enter Output DLC Number
www.multitone.com
Access 3000 Compact Supervisor's Guide
key scroll through the priority
key to scroll through
Page 43