Service Tool List - Epson EB-E01 Service Manual

EB-E01 series
Power on
Replaced part name was possible/
impossible
Optical engine ---
Lamp ---

3.5.10 Service tool list

The following table describes the link of the basic operation manuals and the function about the service tools at
which required before and after parts replacement
Tool Name
Referring to the projector
information.
Writing the projector IPS-
IPS Tool
Tool_Manual
(E).xlsxinformation.
Updating firmware.
CAT
Intra-mart
RESCUE
USB firmware for updater
Easy MP Network firmware for updater
Firmware
SEIKO EPSON
Disassembly and Assembly
Before/after
Required adjustment tasks (service tools name)
replacement
Take the DR data from the "Intramart" data base. (Intramart)
Write the DR data of Optical Engine to the MA Board. (CAT)
---
*2: Calibrate on for (Screen Fit/Frame Fit/Easy setup).**
Perform the Panel Alignment. **
--- Initialize the Lamp information. (AS menu)
(p148).
Necessary to
Function
update
Obtaining the AS menu information.
Reading out the lamp operation time from the MA
Board.
Writing the lamp operation time to the MA Board.
Writing the firmware to the LCP.
Reading the DR data from the old MA Board ofa failed
LCP and save them as file on PC.
o
Writing the DR-data from PC to the new MA Board
ofthe LCP.
Delivery system for the DR data.
o Set the destination.
Writing the firmware to the LCP by USB or USB cable.
Updating the firmware of the LCP by wire network.
3.5.9 The service tools and the adjustment tasks list
TI-No
Tech Exchange TI
AP14-0916-01
(Utilty/Tool)
Tech Exchange TI
AP08-0912E
(Utilty/Tool)
Tech Exchange TI
AP08-0912E
(Utilty/Tool)
Tech Exchange TI
RE001
(Utilty/Tool)
Tech Exchange TI
(General)
Tech Exchange TI
(General)
150
INTERNAL USE ONLY
Reference for the tasks
" 3.5.10 Service tool list (p150)"
" 3.6 Writing the DR Data (p152)"
Non-applied for this model.
" 3.8 LCD Alignment (p162)"
" 4.1.3 Initializing (Resetting) (p190)"
Basic operation manuals
Reference File name
IPS-Tool_Manual(E).xlsx
SERVICE_TOOL_MANUAL_E_*.
pdf
Firmware Ver.**(bin file) release for
USB Updater
Firmware Ver.**(bin file) release for
EasyMPNetwork Update
Revision A