Filter Boards - Epson EB-E01 Service Manual

EB-E01 series

3.3.17 Filter Boards

This part is designated as the Safety Device. When
removing/replacing the part for repair, be sure to refer to
3.5.1 Safety Check after Servicing
follow the procedures specified in the Safety Check after
Serving.
DISASSEMBLY PROCEDURE
1. See Flowchart (p70) and remove all parts up to the component below from
the projector.
PS Ballast Assy (p122)
2. Remove the screw ( ) and remove the "Inlet Fasten Plate".
(This procedure is not applicable to EB-E01/X06/W06/E10/X51/W51/
W52)
3. Remove the screw ( ) and remove the "Inlet Cable".
4. Remove the screw ( ), release the hook (
Board" and the "FB Insulation Sheet".
SEIKO EPSON
Disassembly and Assembly
(p142). After serving,
), and remove the "Filter
135
Filter Board
FB Insulation Sheet
INTERNAL USE ONLY
Inlet Fasten Plate
Inlet Cable
Hook
C.B.P-TITE SCREW,2.5X10,F/ZN-3C
C.P.(O)SCREW,4X6,F/NI
C.P.(S-P1)SCREW,3X8.F/ZN-3C
Revision A