As (After Service) Menu; How To Display The As (After Service) Menu; Displaying The - Epson EB-S01 Service Manual

EB-S01/W01/X14G/S11/X11/S02/S02H/X02/W02/S12/S12H/X12/W12/X14 EH-TW480

5.1 AS (After Service) Menu

The contents of this chapter are only for use of Epson Authorized Services. Do
not disclose them to the end-users.
This menu provides information and settings that are not displayed on the standard
menu.You can check detailed information on the projector with it.

5.1.1 How To Display the AS (After Service) Menu

1. Press the [Menu] button either on the remote controller or on the projector's
control panel for more than 5 seconds.
2. Within 4 seconds after pressing the [Menu] button, press the buttons in order
shown below to display the AS Menu.
[Esc] => [Esc]
(After the AS menu was displayed, all the key operations become invalid for 2
seconds.)
5.1.2 Displaying the Pages
The AS Menu consists of 3 or more pages. You can switch the pages with the [
[ ] button either on the projector or the remote controller. The contents of each page
are described on the following pages.
1st Page
The general operational history of the projector is displayed. The contents displayed on
the screen vary according to the input video sources.
SEIKO EPSON
Appendix
PC/HDMI/USB input's case
Input Signal Input Signal
Frequency Frequency
Sync Polarity Sync Polarity
Sync Mode Sync Mode
Detected Comp Mode Detected Comp Mode
Total Operation Time Total Operation Time
Lamp Op. Time (C) Lamp Op. Time (C)
Lamp Replacement Lamp Replacement
Lamp ON/Lamp OFF Lamp ON/Lamp OFF
Destination Destination
Engine Type Engine Type
P P
R
O O
J J XXXXXXXXXXXXXXXX
] or
No. Item
1
Video source
2
Current input signal
3
Current horizontal/vertical frequency
4
Horizontal/Vertical synchronization polarity
5
Synchronization mode
6
Current detected computer mode
7
Total operation time
Total lamp operation time (converted into low
8
brightness operation)
9
High/Middle/Low brightness lamp operation time
139
XXXXXXXXXX XXXXXXXXXX
: XXXXXXXXXXXXXXXX : XXXXXXXXXXXXXXXX
: H ---.---KHz/ V ---.---Hz : H ---.---KHz/ V ---.---Hz
: H ---- : H ---- / V ---- / V ----
: ---- : ----
: XXXX : XXXX
: 0H : 0H
: 0H : 0H
(H/M/L) (H/M/L) : 0H/ ----H/ 0H : 0H/ ----H/ 0H
: 0Times : 0Times
: 0Times/ 0Times : 0Times/ 0Times
: XXXX : XXXX
: XXXXXX : XXXXXX
XXXXXXXXXXXXXXXX XXXXXXXXXXXXXXXX
XXXXXXXXXXXXXXXX XXXXXXXXXXXXXXXX
XXXXXXXXXXXXXXXX XXXXXXXXXXXXXXXX
XXXXXXXXXXXXXXXX
No.
10
Lamp replacement times
11
Lamp ON/OFF times
12
Destination
13
Type of Optical Engine
14
PW firmware version
15
Sub-processor version
16
IM firmware version
17
Subsystem firmware version
CONFIDENTIAL
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(10)
(11)
(12)
(13)
(14)
(15)
(16)
(17)
Item
Revision C