Lamp Fan (Assy) - Epson EB-E01 Service Manual

EB-E01 series

3.3.13 Lamp Fan (Assy)

DISASSEMBLY PROCEDURE
1. See Flowchart (p70) and remove all parts up to the component below from
the projector.
Optical Engine (Assy) (p113)
2. Remove the screw ( ), and pull the "Lamp Connector" out.
3. Remove the two screws ( ), and remove the "Lamp Fan (Assy)".
Pass the Lamp Connector through the "Lamp Connector
Holder," and keep it pulled out until attaching. After
attaching the holder, fix it with a screw.
Route the "Lamp Fan" cable as shown in the figure below.
SEIKO EPSON
Disassembly and Assembly
The cable should not be caught in the
exhaust duct
Lamp Connector
120
INTERNAL USE ONLY
Lamp Fan (Assy)
C.C.P-TITE SCREW,3X10,F/ZN-3C
C.B.P-TITE SCREW,2.5X10,F/ZN-3C
Revision A