H Key Assy/Upper Case - Epson EB-E01 Service Manual

EB-E01 series

3.3.6.2 H Key Assy/Upper Case

DISASSEMBLY PROCEDURE
1. See Flowchart (p70) and remove all parts up to the component below from
the projector.
Upper Case (Assy) (p80)
2. Remove the two screws ( ) and remove the "H Key Assy".
(This procedure is not applicable to EB-E01/E10.)
3. Remove the two screws ( ) and remove the "Upper Case Cover".
4. Remove the screw ( ) and remove the "Lid Lamp Switch".
5. Remove the following parts:
 Nut Plate M3 x1 (2 pcs)
Route the "Lid Lamp Switch" cable as shown in the figure.
SEIKO EPSON
Disassembly and Assembly
Lid Lamp Switch
Upper Case
Nut Plate M3
Nut Plate M3
(EB-E01/X06/W06/E10/X51/W51)
86
INTERNAL USE ONLY
H Key Assy
C.B.P-TITE SCREW,2.5X8,F/ZN-3C
C.P.F.TYPE1 P-TITE SCREW,1.6X8,F/ZN-3C
Revision A