Bay Door Option; Figure 8 Location Of Dip Switches On Typical Device; Figure 9 Device Address Label - Simplex 4100 Installation Manual

Page 14
Figure 8 Location of DIP Switches
on Typical Device

2.5 BAY DOOR OPTION.

See Figure 10
a. (If applicable) Mark the top of the ribbon cable. Then pull the cable
straight out of its connector.
b. Remove the hair-pin cotter pins (item 1) from the upper clevis pins
(item 2). Then push the clevis pins inward and lower the door.
c. Free the lower end of the retainer cable (item 3) by removing the screw
and washer (items 4 and 5).
d. Remove the hair-pin cotter pins (item 6) from the lower clevis pins
(item 7). Then push the clevis pins inward and remove the door.
e. Store the door and its hardware in a safe, clean and dry place until all
wires are terminated in the 4100 panel.
Document No.: 4100-M011
INSTALLATION MANUAL

Figure 9 Device Address Label

March 1998
SIMPLEX 4100 EWIS
Issue 1.0