Medema Mini Crosser M2 Service Manual page 46

Medema A/S
Service manual P9-0157-S
The plug and fuse must be fitted into
the hole. Remember to also install the 2
small fuses again.
Tighten the screws.
The programming is changed to single-ended. See the
Programming/technician menu section.
After completing installation, turn the scooter on and check that
the magnetic brake clicks when the accelerator is activated.
When the accelerator is released, it must not be possible to
push the scooter.
Use Loctite 406 for fitting the throttle.
Connect the hand throttle to the 3-pin
plug where the standard potentiometer
was connected.
46 of 70 Version 2.0.9 - 2018