Medema Mini Crosser M2 Service Manual page 27

Medema A/S
Service manual P9-0157-S
Parameter description
Max fwd speed slow This value is used when the "slow/fast" switch is set to "slow"
Min fwd speed fast This value is used when the "slow/fast" switch is set to "fast"
Min fwd speed slow This value is used when the "slow/fast" switch is set to "slow"
Max rev speed fast This value is used when the "slow/fast" switch is set to "fast"
Max rev speed slow This value is used when the "slow/fast" switch is set to "slow"
Min rev speed fast This value is used when the throttle potentiometer is set to
"slow" and the "slow/fast" switch is set to "fast"
Min rev speed slow This value is used when the throttle potentiometer is set to
"slow" and the "slow/fast" switch is set to "slow"
Speed limit pot. If the value is set to ON, the S-180 will check for the
enabled presence of a valid throttle potentiometer signal on pin
9. If a valid signal is not detected, S-180 will use the
programmed minimum speeds.
Throttle invert Wig-wag: If the value is set to OFF it means you must use
the four-finger grip for driving forward. And the thumb grip
for reversing. The ON value means the opposite.
Single-ended: A switch is used to switch between driving
forward and reversing.
Sleep timer A value of 0-20 minutes is entered here. If the handlebars
are idle for longer than the number of minutes entered, it
will go into sleep mode. If the value set to 0, sleep mode is
switched off.
Throttle type Wig-wag - four finger grip/thumb grip
Single ended - hand throttle
Throttle deadband Indicates in percentages the proportion of the throttle's
potentiometer which should be the zero-zone, i.e. the range
the scooter does not run in the event of a slight activation.
Ensures that the scooter's main potentiometer always
returns to zero, and thus the scooter stops when it should.
Should normally not be adjusted, but may be necessary if,
for example, you switch from Wig-wag to foot throttle, or
similar.
Throttle gain Used to set the throttle, so that the scooter achieves
maximum speed just before the throttle reaches its fully
open position.
If a user has limited hand function, this parameter can
be used to set the scooter to run at full speed by turning
the throttle e.g. 50-60%. For this, Throttle Gain must be
increased.
Drive: S-180 will run if the throttle is open when the scooter
Throttle operated at
power-up is started.
Inhibit: S-180 will run if the throttle is open when the
scooter is started. If the throttle is closed, Inhibit is
disengaged and the scooter can run again.
Trip: S-180 will not run if the throttle is open when the
scooter is started. It will record it as a mistake, which can
be seen in the error log under a trip code. The key must be
turned to 0 and back to 1 before it can run again.
27 of 70 Version 2.0.9 - 2018