Medema Mini Crosser M2 Service Manual page 26

Hide thumbs Also See for Mini Crosser M2:

User manual (56 pages)

Table Of Contents

Table of Contents

Medema A/S

Service manual P9-0157-S

Parameter description

Acknowledge

You can choose between no sound and a low or high horn

blast to signal whether the alarm has been activated.

The indicators will always flash once when the alarm is

activated.

The alarm lasts for 15 seconds before switching off. Any

further disturbance will trigger it again.

An activated alarm is turned off by turning on the scooter

with the key.

Sensitivity

This value adjust the sensitivity of the alarm. The sensitivity

value is set between 0-100, where 100 is the most sensitive.

Tilt (Extra)

Present

Here you can switch ON the tilt indicator, after the sensor

unit has been connected to the cable network at the back

of the scooter.

Maximum UP/DOWNHILL tilt. Enter the tilt at which the

user should be warned not to continue. The value must be

entered in degrees.

Maximum SIDEWAYS tilt. Enter the tilt at which the user

should be warned not to continue. The value must be

entered in degrees.

Actual X

Displays the current up/downhill tilt of the scooter on the

display.

Actual Y

The same as the Current X, only sideways.

Tilt time

Enter the length of time the tilt threshold must be exceeded

before the warning horn is activated (0.5 - 2.5 seconds)

Warning buzzer

You can choose Off, Beep or Buzzer. Since the sensor is

a simple accelerometer, it will be possible to generate a

warning beep during sharp turns or when driving on very

rough terrain. It is recommended in such cases to mute the

sound and just watch out for warnings on the display.

Calibrate

Before an installed tilt module can be used, it must be

calibrated so that it shows 0 degrees on level ground with

the user on the seat. This is because differently sized

users do not put equal amounts of pressure on the shock

absorbers.

Select On while the user sits quietly in the seated position

on the seat.

P&G

The PC programme should only be used by fully trained personnel, and should not

be disclosed to unauthorised personnel. By using this software, the operator takes

full responsibility for the programme's settings and performance following setting

changes.

Forward acc fast