Radar Stand Dimension - Furuno WR2120 Installation Manual

4.1.4. Radar stand dimension

The mounting part of ATU should be
designed as shown in the outline drawing of
the Antenna Unit (84-001-300G- *).
These sizes are based on 165 cm tall of
service engineer.
Two drawing below shows front and side view
of radar. Each side of scaffold height is
different.
The load capacity of the scaffold has to be
200 kg or more. (Assume weight for 2 people)
The material
recommended to be rustproofed iron.
Scaffolding is recommended to set two different heights that assuming to maintain the inter parts of the
radome or a case of removing the upper radome.
Different
height
of the scaffolding
CABLE ENTRIES
2pcs.
4xM16 BOLTS
φ70
BULL'S EYE LEVEL
is 4xφ5
DRAIN HOLES
Extract part from outline drawing of the
antenna unit (84-001-300G-*)
ATU mounting bracket recommendation：
Equilateral angle steel (L-angle)
Size：80x80x6 (mm)
Make this dimension less for avoiding interfere
with the bracket from lifting fixture.
Lifting fixture
The height of the
facing
shall be the same
height.
21
500
°
70
°
°
°
60°
°
30°
φ158
°
Figure 4.7:
scaffolds
500
°
°