Data Processing Unit; Startup Dpu; Add External Data Storage Device; Renew A-Threshold - Furuno WR2120 Installation Manual

4.4.

Data Processing Unit

(2)
(1)
DC cable
AC cable
Power switch
button
(1)
(3)

4.4.1. Startup DPU

1) Turn "ON" the power of DPU.
2) Enter the following below if DPU is asking for login:
User name: radar
Password: radar
3) RainMap (Software for the radar operation) will startup automatically after DPU turned on.
4) Remain a safe distance from radar. Radar transmit radio wave can damage human body
especially eyes within the danger zone.
5) Plug in the power cable of ATU/SPU to the local outlet.
6) Turn on the breaker in the SPU to turn on the power of ATU/SPU.

4.4.2. Add external data storage device

The most common way users save observed data in to the external HDD for temporary and
transfer it via network.
Adding an external HDD is easy, it just plug-in a
USB3.0 cable into USB3.0 connector of DPU
and external HDD. Then, check the directory
path of external HDD from [Computer] -> [Hard
Disk Drives] screen of DPU.

4.4.3. Renew A-threshold

1) Click [Connect] in the pull-down menu of
[Radar operation] to start RainMap operation.
2) Press [Alt]+[Ctrl]+click [Renew A-threshold]
for adjusting the radar A-threshold. It will take
approx.10 minutes to complete. (Refer to the
"Operator's manual" for detail)
(4)
(6)
(3)
(5)
(4) (6)
(5)
Setup Data Processing Unit:
(1) Connect DC power cable of DPU-PS to
DPU.
(2) Connect AC power cord to DPU-PS and
to electrical outlet.
(3) Connect DVI cable from LCD monitor to
DPU. Also connect the power cord from
LCD monitor to a local power outlet.
(4) Connect LAN cable from LAN port 1 of
PXI (in SPU) to DPU LAN port 1.
Connect USB/LAN adapter that LAN will
(5)
be from MONI-CON (inside the ATU).
Other USB ports are using for keyboard,
mouse, and external HDD.
(6) Connect LAN cable from router to LAN
port 2 for using Internet. The router and
the LAN cable for Internet is local supply.
Notice:
1> Bundled power code is dedicated for
Japan/US use and can be used up to 125V.
Therefore, the local user will be necessary
to prepare a replacement power cords (e.g.
200-240V) for local use. (Refer to Appendix
D)
2> Do not use the same IP address on ATU.
Do not put heavy object on the DPU. It may
3>
deform the DPU chassis.
38