Furuno WR2120 Installation Manual page 3

Do not disassemble or modify the equipment.
Fire or electrical shock can occur.
Use only the specified power cord/cable.
Fire or damage to the equipment can result if a different cable is used.
Use the power supply grounded certainly.
Electrical shock or defect of operation can occur.
When a thunderbolt is expected, do not approach a system or do
not touch a hand.
There is a possibility of receiving an electric shock.
A worker's safety is guaranteed however the radar's internal protection devices only
protect against indirect lightning and surges to the radar components. In case of a direct
lightning strike these protection devices may not protect radar or surrounding personnel.
Install the radar lower than 2,000m altitude.
When the radar is installed above 1,000m, the life time will be shorter due to deterioration
of oil seal and the grease leakage by low pressure, especially for ball bearings in the
motors, fans, and spindles. The radar must be installed lower than 2,000m altitude.
Attach securely protective earth to the unit.
The protective earth (grounding) is required to the AC power supply to prevent electrical
shock.
Do not put liquid-filled containers on the top of the equipment.
Fire or electrical shock can occur if a liquid spills into the equipment.
Establish best possible surrounding space for apparatus.
This helps eliminate performance degradation and failure.
Do not impact the LCD glass.
Serious injury may occur due to broken glass.
RADIATION WARNING LABEL
Radiation warning labels are attached to the equipment. Do not remove any label.
If a label is missing or damaged, contact us for the replacement.
POWER SUPPLY LABEL
100-240 VAC
SINGLE PHASE, 50/60 Hz
POWER CONSUMPTION: MAX. 650W
RATED AMPERE: 6.5-4.3A (100-150VAC)
Note: Total maximum power consumption of ATU (350W) and SPU (300W).
CAUTION
Name:
Type:
Code No.: 100-266-891-10
*1
3.2-2.7A (200-240VAC)
Radiation Warning Label
03-142-3201-1
Inside SPU
ii
Outside ATU