Furuno WR2120 Installation Manual page 37

5) Lift the upper radome until spring clamp
contacts the radome base flange.
7) Check antenna orientation. If the antenna is facing at horizontal direction, then rotate the
antenna to a counter weight down to face up around at 90 degrees (upward).
8) Lift up the upper of radome until the M10 nut
contacts radome base flange.
6) Remove spring clamp from bottom of
flange and reattach it at upper of the
flange.
Counter
weight
9) Fasten the spring clamp above the
flange.
31
Spring clamp
M10 nut
base