Closing The System Board From The Rear - Xerox Copycentre C20 User Manual

Closing the System
Board from the Rear
Complete the following steps to close the Printer System
Board after you have installed the flash memory SIMM:
1 Push on the access cover until it snaps into place.
2 Do one of the following:
• Reattach the printer rear cover.
- Insert the two tabs on the bottom of the cover into
the slots on the back of the printer, as shown.
- Push the cover forward until it snaps firmly into
place.
• Reinstall the optional Tray 2 (if one was attached). If
you need help, see the section "Input Tray 2"
(page C-25).
Appendix C: Printer Options
Flash Memory
C-13