Accessing The System Board From The Front - Xerox Copycentre C20 User Manual

Accessing the System
Board from the Front
To install or remove memory, you must access the printer
system board which is under the input tray. Follow these
steps:
1 Unplug the printer power cord.
2 Disconnect all cables from the back of the printer.
3 Remove the input tray and output bin unit.
A Grasp underneath the unit, and pull up hard to a 45°
angle until it releases from the printer.
B Hold the unit at this angle and pull it away from the
printer.
4 Remove the system board access cover.
A Locate the tab on the access cover and push it toward
the printer.
B Grasp the tab and lift the access cover until it touches
the metal bar.
C Pull the access cover straight out from the printer.
5 Continue with the section "Installing Printer Memory" on
the next page.
Printer Memory
Appendix C: Printer Options C-5