Calibrating The Uw/W 100; Calibrating The Rear Tensioning System; Checking The Calibration - Xerox 82xx User Manual

3.3 CALIBRATING THE UW/W 100

3.3.1 Calibrating the rear tensioning system

Parts and Tools needed
No. Description
1 Synthetic paper strip
2 Hexagon wrench 2,5 mm
3 Hexagon wrench 3 mm
4 Hexagon wrench 4 mm
No. Description
1 Tape
2 Pencil

3.3.1.1 Checking the calibration

The procedure below describes the calibration check of the rear tensioning system. The method to check
the front tensioning system is the same. However, the front and rear tensioning bars use different bars to
complete the calibration.
Procedure :
P 1 : P
ART REPARING THE SYNTHETIC PAPER STRIP
Put the pressure rollers in the up position.
Step 1 :
Go to the back of the machine.
Step 2 :
Create a loop with the synthetic paper strip around the upper bar of the rear tension system at
Step 3 :
the left side when standing at the back of the printer.
FRONT
3-10
Included in kit
NOT included in kit
REAR
Quantity
1
1
1
1
Quantity
1
1