Using Build Job And Sample Set - Xerox Document Centre 240 DC User Manual

Using Build Job and Sample Set

Typical Application
Produce multiple sets of a document where individual
segments require unique feature program selections.
Procedure
1. Load the originals for the first job segment.
2. Press the Basic Copy Tab and program the
3. Depending on the configuration of your machine
4. Press Build Job then press the Build Job On button.
5. Press the Start (
6. Repeat this procedure for each remaining segment.
7. After the final segment has been scanned press End
8. After you review the initial set, press the Job Status
9. Touch your job to select it.
10. If you are satisfied with your initial set press Release.
Xerox Document Centre User Guide
appropriate features for the first segment of the job.
press the More Copy Features Tab or the Job
Assembly Tab. If the More Copy Features Tab is
selected press the Job Assembly Tab.
Press the Save button. Select Sample Set and Save to
produce a single complete set for review.
) button.
The appearance of the End Build Job button indicates
that the machine is in the image collection mode.
Build Job.
A single review set will be produced because Sample
Set was selected.
button to display a listing of queued jobs.
Otherwise, delete it and start again.
Page 49