Using Build Job And Sample Set - Xerox 490 DC/ST User Manual

Using Build Job and Sample Set

Xerox Document Centre User Guide
Typical Application
Produce multiple sets of a document where individual
segments require unique feature program selections.
Procedure
1. Load the originals for the first job segment.
2. Press the Basic Copy Tab and program the
appropriate features for the first segment of the job.
3. Depending on the configuration of your machine
press the More Copy Features Tab or the Job
Assembly Tab. If the More Copy Features Tab is
selected press the Job Assembly Tab.
4. Press Build Job then press the Build Job On button.
Press the Save button. Select Sample Set and Save to
produce a single complete set for review.
5. Press the Start (
6. Repeat this procedure for each remaining segment.
7. After the final segment has been scanned press Build
Job Controls then press End Build Job.
A single review set will be produced because Sample
Set was selected.
8. After you review the initial set, press the Job Status
button to display a listing of queued jobs.
9. Touch your job to select it.
10. If you are satisfied with your initial set press Release.
Otherwise, delete it and start again.
) button.
Page 55