Recall Settings - Xantrex XDC Operating Manual

Recall
After you have saved one or more settings, you can press RECALL to retrieve them
from the power supply's non-volatile memory or to run an auto-sequence program.
Settings
(You can also recall stored settings through your Power ON configuration. See
"Configure Power ON Settings" on page 84.)
To retrieve a setting using RECALL:
Step #
1. If you want a different setting besides Set 1, use the arrow keys or numeric keypad.
Four options are available from the Recall memory:
1. Last Setting: Returns the setpoints to values stored before power was turned off.
2. User Settings: Returns the setpoints to one of ten possible saved values.
3. Factory Preset: Returns the setpoints to the original out-of-the-box values.
4. Auto Sequence: Returns control of the setpoints to one of ten possible saved
To access these options, press RECALL repeatedly until the correct option appears,
or press the arrow keys. Pressing RECALL lets you scroll through the options in the
direction listed above. Pressing the arrow keys lets you cycle through the options in
either direction.
To restore the last setting:
Step # Do This
Release 3.0
Do This
1
RECALL
2
RECALL
3
ENTER
4
ENTER
programs. (For further information, see "Program Auto Sequence" on page 87.)
1 Press once.
RECALL
2 Press to restore last
ENTER
setting.
Power Supply Operation
You Will See
Last Setting
User Settings
1
User Set 1
This setting is retrieved from memory,
the power supply's output changes to
match the setting, and the display
returns to its default operating mode.
You Will See
Last Settings
Operation
79