Device-Specific Error List - Xantrex XDC Operating Manual

Error Messages

Device-Specific Error List

Device-Specific Error List
An error in the range [-399, 300] or [1, 32767] indicates that the instrument has
detected an error which is not a command error, a query error, or an execution error;
some device operations did not properly complete, possibly due to an abnormal
hardware or firmware condition. These codes are also used for self-test response
errors. The occurrence of any error in the class causes the device-specific error bit
(bit 3) in the Event Status Register to be set.
Table C.3 Device-Specific Error List
Error
code
-300
-310
-313
-314
-315
-321
-330
-350
-360
-361
-362
-363
218
Error Message Description
Device-specific error.
Indicates that the power supply could not complete the operation due to some
condition of the power supply.
System error.
This error is queued when the power supply cannot convert the input to a
calibrated value.
Calibration memory lost.
Save/recall memory lost.
Indicates that the non-volatile data saved by the *SAV command has been lost.
Configuration memory lost.
Indicates that non-volatile configuration data saved by the power supply has
been lost.
Out of memory.
An internal operation needed more memory than was available.
Self-test failed.
Queue overflow.
A specific code entered into the queue in lieu of the code that caused the error.
This code indicates that there is no room in the queue and an error occurred
but was not recorded.
Communication error.
This is the generic communication error for errors which cannot be classified
below.
Parity error in program message.
Parity bit not correct when data received.
Framing error in program message.
A stop bit was not detected when data was received, e.g. a baud rate
mismatch.
Input buffer overrun.
Software or hardware input buffer on serial port overflows with data caused by
improper (or nonexistent) pacing.
Operating Manual for XDC Series Power Supply