Selecting Enet As The Communication Port; Figure 2-19 Assigning Ip Settings - Xantrex GRIB and Ethernet interface Operating Manual

Selecting ENET as the Communication Port

M370078-06

Figure 2-19 Assigning IP Settings

9. In the IP Configuration section, click the radio button next to "Use the
following IP configuration."
Important: If you are working within a network system, please contact the
network administrator for the appropriate information to complete the IP
Address, Subnet Mask and Default Gateway fields
10. Click OK at the bottom of the page to complete the task.
11. Repeat this procedure for every power supply. Every device must
have a unique fixed IP address.
Once the XG unit with the ENET option has the option card configured,
you'll need to configure the XG to use the ENET option card as the active
communication port.
To select ENET as the communication port:
1. Turn the 9-position Mode control to PGM.
rE is displayed in the output voltage display.
Configuring the Device Using DeviceInstaller
2-17